Lubrication - Brother S-6200A Instruction Manual

3-3. Lubrication

Do not connect the power cord until lubrication has been completed, otherwise the machine may operate if the
treadle is depressed by mistake, which could result in injury.
Be sure to wear protective goggles and gloves when handling the lubricating oil, so that it does not get into your
eyes or onto your skin.
If care is not taken, inflammation can result. Furthermore, do not drink the lubricating oil. Diarrhea or vomiting may
result.
Keep the oil out of the reach of children.
3844M
CAUTION
The sewing machine should always be lubricated and the
oil supply replenished before it is used for the first time,
and also after long periods of non-use.
Use only the lubricating oil (Nippon Oil Corporation
Sewing Lube 10N; VG10) specified by Brother.
* If this type of lubricating oil is difficult to obtain, the
recommended oil to use is <Exxon Mobil Essotex SM10;
VG10>.
1. Tilt back the machine head.
2. Slowly pour in lubricating oil until the oil level reaches the
HIGH mark.
* If the oil level drops below the LOW mark, add more
3846M
lubricating oil.
S-6200A
3. INSTALLATION
10. Cotton stand
(1) Cotton stand
NOTE:
Securely tighten the nut (4) so that the
two rubber cushions (2) and the washer
(3) are securely clamped and so that
the cotton stand (1) does not move.
8