Adjusting The Stitch Length; Using The Thread Wiper (-40[] Specifications); Using The Knee Lifter - Brother S-6200A Instruction Manual

4-6. Adjusting the stitch length

4-7. Using the thread wiper (-40[] specifications)

4-8. Using the knee lifter

Turn the stitch length dial (1) until the desired stitch length
number is aligned with the pin (2) above the dial.
The larger the number, the longer the stitch length will be.
(The numbers on the dial are for use as a guide. The
length of the finished stitches may vary depending on the
type and thickness of material being sewn. Adjust while
looking at the finished stitches.)
When turning the stitch length dial (1) from a larger
setting to a smaller setting, it will be easier to turn the dial
if the reverse lever (3) is pushed to the halfwaydown
position.
1971B
Press the thread wiper key (1) on the operation panel so that
the indicator illuminates. If this is done, the thread wiper (2)
will operate after the thread is trimmed.
1972B
The presser foot (2) can be raised by pressing the knee lifter
plate (1).
1973B
S-6200A
4. PREPARATION BEFORE SEWING
20