Table of Contents
Advertisement
Metric: This is the number of hops (routers) to pass through to reach the destination
lAn. It must be between 1 and 15.
Device: Show the interface that goes to the next hop (router), such as a lAn port.
Use: This is the counter for access time.
Edit: This is for editing the route, and is not shown for the system default route.
Drop: This is for dropping the route, and is not shown for the system default route.
ADD ROUTE — If another router with a lAn-to-lAn connection is part of the
configuration, it may be necessary to create a static routing on the router that is
the gateway to the Internet.
Destination IP Address: enter the IP address of the destination lAn.
IP Subnet Mask: enter the subnet mask address of the destination lAn.
Gateway IP Address: This is the gateway IP address where packets are sent.
Metric: This is the number of hops (routers) to pass through to reach the destination
lAn. It must be between 1 and 15.
Announced in RIP: Select "Yes" and this routing path will be propagated to
other hosts through RIP (routing information protocol) broadcasts. Select "no"
and this routing path will be kept private, not to be included in RIP broadcasts.
NAT
0
Web MAnAGeMenT ConFIGURATIon
Advertisement
Table of Contents
