Table of Contents
Advertisement
setup/instAllAtion
once you're familiar with the front and rear panels of the Wireless AdSl2+
broadband Modem Router, the setup and installation of the device is easy.
1. From the AdSl port, connect the router to your AdSl network using the RJ- 1 1
telephone cable provided.
2. From any of the lAn ports, connect the router to your PC, hub, switch or other
component using the ethernet Cat5 RJ-45 cable provided.
3. Connect the router's power outlet to a power source using the power adapter
provided. NOTE: Use only the power adapter included with this device.
4. Check that the green AdSl led is on, indicating a successful connection. If
the AdSl led is blinking — indicating that no connection has been made —
contact your Internet service provider.
3. softwAre/setup wizArD
This router provides a setup wizard used to configure the AdSl settings. This
wizard collects and enters AdSl settings from some Internet service providers
(ISPs) simply by selecting the ISP when prompted. If you can't find your particular
ISP listed in the wizard, refer to the Quick Start instructions in the Web Management
Configuration section.
before starting:
• Make sure the AdSl cable is connected to the router correctly. When the
AdSl cable is working normally, the AdSl led will be on.
• Uninstall all dial-up programs previously installed for the USb modem or
other dial-up devices.
• It is recommended that the router first be configured with the ethernet cable
connected prior to setting the wireless functions.
NOTE: This setup wizard can be run in Windows 98Se, Me, 2000 or xP. The
following procedures represent Windows xP, but are similar for 98Se/Me/2000.
1. Insert the enclosed setup Cd (featuring the setup wizard) into your Cd-RoM
drive. The Autorun.exe program should be executed automatically. If not,
run Autorun.exe manually from the "Autorun" folder on the Cd.
2. Click on "Setup Wizard" when the
initial menu appears on screen. The
wizard will search for the router. If
the router can't be found, enter the
IP address and the password of the
router, then click "next" to search
again.
SoFTWARe/SeTUP WIZARd
Advertisement
Table of Contents
