Using Your Printer With A Usb Cable; Installing Usb Driver In Windows 98/Me - Xerox Phaser 3210 User Manual

Using Your Printer with a USB Cable

If you have a USB (Universal Serial Bus) port enabled on your computer, and if
your computer is running Windows 98/ Me/ 2000/ XP, you can connect your
Phaser 3210 printer to the USB chain of devices.
Note: • To connect the printer to the USB port of the

Installing USB driver in Windows 98/Me

1. Install printer driver
2. Connect printer with
USB cable and
install USB driver
A.10
A
PPENDIX
computer requires a certified USB cable.
And the length should be less than three meters.
• You must install the printer driver before you
connect the USB cable in Windows 2000/XP.
To operate your printer with a Windows PC, you must install the
printer driver. Place the CD-ROM in the CD-ROM drive and
perform the instructions on page 2.9.
1
2
Make sure that both the printer and computer are turned
ON.
Plug one end of the USB cable into the USB port on the
printer.
To the USB port
on PC