7
Push the SIMM down until it snaps into
place.
Make sure that the SIMM is secured in
place by the metal clips and pins on
both sides of the connectors.
When you disassemble the
Note:
memory card, push out on the metal
clips at each end of the connector, and
pull it as shown.
8
Reassemble the shield cover, turn the
printer back over, and replace the toner
cartridge.
9
Reconnect the printer cable and the
power cord and turn the printer on.
Then, replace the supports.
Installing Optional Memory
Pin
Metal clip
A.27
A
PPENDIX