Table of Contents
Advertisement
Paper Specifications
Envelopes with Double
Side Seams
Envelopes with
Adhesive Strips or Flaps
Envelope Margins
Envelope Storage
A.8
A
PPENDIX
Double side-seams construction has vertical seams at both ends
of the envelope rather than diagonal seams. This style may be
more likely to wrinkle. Be sure the seam extends all the way to
the corner of the envelope as illustrated below.
Correct
Incorrect
Envelopes with a peel-off adhesive strip or with more than one
flap that folds over to seal must use adhesives compatible with
the heat and pressure in the printer. The extra flaps and strips
might cause wrinkling, creasing, or even jams and may even
damage the fuser.
The following gives typical address margins for a commercial
#10 or DL envelope.
Type of Address
Return address
Delivery address
Notes:
• For best print quality, position margins no closer than 15 mm
(0.6 in.) from the edges of the envelope.
• Avoid printing over the area where the envelope's seams
meet.
Proper storage of envelopes helps contribute to print quality.
Envelopes should be stored flat. If air is trapped in an envelope,
creating an air bubble, then the envelope may wrinkle during
printing. See "Printing on Envelopes" on page 4.7.
Minimum
15 mm (0.6 in.)
51 mm (2 in.)
Maximum
15 mm (0.6 in.)
89 mm (3.5 in.)
Advertisement
Table of Contents
Troubleshooting
