Peripheral Interface Specifications; Table 5-5. Peripheral Interface Specifications - Fujitsu Stylistic 3500 Technical Reference Manual

Peripheral Interface Specifications

Specifications for peripheral interfaces on the Stylistic 3500 pen tablet are given in Table 5-5. For
specifications on peripheral interfaces provided by the port replicator, see "Port Replicator Specifications"
later in this chapter. Also note that pin assignments and other details for peripheral interfaces on the
Stylistic 3500 pen tablet are given in Chapter 6 of this manual.
Feature
PC Card Slot One Type II PCMCIA CardBus slot.
Compliant with PC Card Standard Rev. 3.0
IDE Interface Supports one IDE hard disk drive (2.5 inch)
Modem Port RJ-11 connector for internal modem
Serial Port Standard 9-pin connector that allows you to
connect an external serial device.
Universal Serial Bus One USB Series A receptacle on pen tablet.
Port (USB A)
IrDA Port Infrared transceiver built into pen tablet.
Infrared Keyboard Infrared receiver built into the pen tablet for
Port use with an optional infrared keyboard.
DC Power Input 16 VDC ±10%, 3.36 A
Connector vendor: Hosiden
(Hosiden part number HEC3900-01-010)
This connector is a EIAJ-RC5320A standard
connector.
Audio Jacks Monaural microphone input mini jack
Stereo headphone output mini jack
System Interface 200-pin connector
Port
High-Usage 8-position external contact connector
Contacts provides connections for: DC power input and
USB.
Floppy Disk Drive 26-pin floppy disk drive connector
Port

Table 5-5. Peripheral Interface Specifications

Specification Comments
Supports CardBus and PCIC (PC Card I/O
Cards)
IDE hard disk drive is preinstalled at factory.
See "Internal LAN/Modem Specifications" on
page 44 for more information. Note that the
LAN portion of the device is accessible only
via the mini-dock.
Compliant with IrDA Standard Revision 1.1
Supports: FIR (4 Mbps max),
SIR (115 Kbps max)
Range: approximately 1 M, 15 degrees from
center
Proprietary Fujitsu receiver.
Range: approximately 1 M, 15 degrees from
center
External power can be connected to DC
input connector on the pen tablet, mini-dock,
port replicator, or high-usage contacts. See
"DC Power Inputs" on page 67 for more
details.
Standard 3.5 mm mini jacks.
See "Audio Jacks" on page 59 for details on
audio inputs and outputs.
For use with Stylistic 3500 port replicator or
mini-dock.
See "High Usage Contacts" on page 47 for
signal assignments of the high-usage
contacts.
For use with Fujitsu floppy disk drive.
Peripheral Interface Specifications
5
41