V.25Ter At Commands - Fujitsu Stylistic 3500 Technical Reference Manual

V.25ter AT Commands

Command
+GMI
+GMR
+GMM
AT+A8E=<v80> v8o
v8a
v8cf
AT+A8E?
AT+A8E=?
+A8I:<v8cf><CR>
+A8M=<hexadecimal
coded CM or JM octet
string>
+A8A:<type><CR>
Specification
Return 'Lucent Data/Fax'
Return Lucent driver version number (e.g., 5.54)
Return 'H.324 video-ready rev. 1.0'
1: The default value disables the CI origination
option while in V.8 negotiation. However, the
modem, when initiating the call as a data call,
detects ANSam and is capable of starting in
V.34 mode.
6: Enables DCE control of V.8 and CI option.
1: The default value disables the CI option while
in V.8 negotiation. However, the modem,
when answering a call, sends the ANSam
and is capable of starting in V.34 mode.
5: Enables DCE control of V.8 and CI option.
21h: Call function for H.324 calls.
c1h: Call function for DSVD calls.
Refer to V.8 document for coding.
1: Indicates V.8 ANSam signal flags.
0: Indicates no ANSam signal detected.
Description
Manufacturer Identification
Version/Revision Information
Modem Identification
Defined for two conditions: as a
parameter to configure V.8
originating and answering
operation while the DCE is
on-hook.It initiates an action if
the DCE is off-hook. If enabled,
V.8 negotiation does not
preclude simultaneous
implementation of other
negotiation means like V.8bis,
V.18, or V.32bis.
Report current values of
subparameter.
Report supported ranges of
values <v8o>, <v8a>, <v8cf>
This indication is used by an
answering DCE if +A8E,
<v8a>!=0, to indicate detection of
a V.8 CI signal, and report the
recovered Call Function octet(s).
Value <v8cf> is a hexadecimal
code octet that can take values
as shown above in +A8E
command.
Directs the DCE to send a V.8
CM or JM signal using the
specified hexadecimal coded
string.
AT Commands Table
9
86