Peripheral Interface Specifications - Fujitsu Stylistic 2300 Technical Reference Manual

Peripheral Interface Specifications

Specifications for peripheral interfaces on the Stylistic 2300 pen tablet are given in Table 5-5. For
specifications on peripheral interfaces provided by the port replicator, see "Port Replicator Specifications"
later in this chapter. Also note that pin assignments and other details for peripheral interfaces on the
Stylistic 2300 pen tablet are given in Chapter 6 of this manual.
Feature
PC Card Slots Two stacked PC Card slots
Compliant with PC Card Standard Rev. 3.0
Supports:
CardBus
Zoomed Video Port (slot 1 only)
PCIC (PC Card I/O Cards)
IDE Interface Supports one IDE hard disk drive (2.5 inch)
Modem Port RJ-11 connector for internal modem
Keyboard/Mouse 6-pin PS/2-style
Port
Parallel Port 25-pin D connector, female
Video Port Standard 15-pin video connector with Display
Data Channel (DDC) display support.
Serial Port A Male 9-pin D connector.
NS 16C550 compatible, fully functional
RS-232C serial port.
Universal Serial Bus One USB Series A receptacle on pen tablet.
IrDA Port Infrared transceiver built into pen tablet.
Compliant with IrDA Standard Revision 1.1
Supports: FIR (4 Mbps max),
SIR (115 Kbps max)
Range: approximately 1 M, 15 degrees from
center
DC Power Input 16 VDC ±10%, 2.7 A
Connector vendor: Hosiden
(Hosiden part number HEC3900-01-010)
This connector is a EIAJ-RC5320A standard
connector.
Audio Jacks Monaural microphone input mini jack
Stereo headphone output mini jack
5-4 Hardware Specifications
Table 5-5 Peripheral Interface Specifications
Specification Comments
System accepts:
Two Type I or Type II PC Cards, or
one Type III PC Card
IDE hard disk drive is preinstalled at factory.
Internal modem available only in North
America. See "Internal Modem
Specifications" on page 5-8 for more
information.
Supports Fujitsu low-power keyboards and
most PS/2-style keyboards and mouse
devices. (Hotkey functions on older Fujitsu
keyboards are not supported.)
Operational modes:
output only, bidirectional, ECP
External monitor only or simultaneous with
LCD.
Port replicator provides a second fully
functional serial port (serial port B).
The USB port on pen tablet is disabled when
port replicator is connected and the two USB
ports on the port replicator are enabled.
Serial port B can be assigned to either the
IrDA port on pen tablet or the 9-pin RS-232C
serial port B connector on the port replicator.
IrDA port is disabled when 9-pin connector is
selected for the serial port B device.
For use with FMWAC4A, FMWAC4B, and
FMWAC4C AC adapters (AC adapter
module CA01007-0520) or FMWCB2 auto
adapter (CA01007-0360).
External power can be connected to DC
input connector on the pen tablet, port
replicator, or high-usage contacts. See "DC
Power Inputs" on page 7-2 for more details.
Standard 3.5 mm mini jacks.
See "Audio Jacks" on page 6-13 for details
on audio inputs and outputs.
Microsoft Corp. Exhibit 1020