Appendix C Agency Notices; Fcc Notices - Fujitsu Stylistic 3500 Technical Reference Manual

Appendix C
Agency Notices

FCC Notices

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. Changes or modifications not expressly approved by Fujitsu PC Corporation
could void the user's authority to operate the equipment.
Notice to Users of Radios and Television
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If the
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet that is on a different circuit than the receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded interconnect cables must be employed with this equipment to ensure compliance with the
pertinent RF emissions limits governing this device.
Notice to Users of the US Telephone Network
Note: Stylistic 3500 pen tablets shipped outside of North America do not have an internal modem. The
following information applies only to those systems with an internal modem.
The Stylistic 3500 pen tablet is supplied with an internal modem which complies with Part 68 of the FCC
rules. On the pen tablet is a label that contains the FCC Registration Number and Ringer Equivalence
Number (REN) of this system, along with other information. If requested, users must provide their
telephone company with the following information:
• The telephone number to which the pen tablet is connected
• The Ringer Equivalence Number (REN) for this equipment
• The information that the system requires a standard modular jack type USOC RJ-11C which is FCC
Part 68-compliant
• The FCC Registration Number
This equipment is designed to be connected to the telephone network or premises wiring using a
standard modular jack type USOC RJ-11C which is FCC Part 68-compliant.
The REN is used to determine the number of devices you may connect to your telephone line and still
have all those devices ring when your number is called.Too many devices on one line may result in
9
9
9
92