Tec Grounding Consideration; Tec Module Operation; Quick Start; Tec Main Screen - Newport 8000 User Manual

Chapter 4
4.3.1

TEC Grounding Consideration

The TEC output of the module is isolated from chassis ground, allowing either output
terminal to be grounded at the user's option.
4.4

TEC Module Operation

4.4.1

Quick Start

After the power-on sequence is complete, the 8000 goes to the Master display. To
set up a TEC module, press the MENU button, then the Modules soft key, then
select the slot that the module resides in, and finally, the Setup soft key. At this
point, the display shows all TEC parameters. Using the cursor keys, the numerical
keypad, knob and ENTER, select the desired functions and set the parameter values.
When finished, return to TEC display with Prev (previous) soft key.
Enter the desired set point value using the numerical key pad and ENTER, or use the
knob. Press the OFF soft key to operate the TEC. The OFF changes to ON. To
turn the TEC off, press the ON soft key.
4.4.2

TEC Main Screen

The TEC main screen is shown Figure 24 and described below.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Temperature Controller Module Operation
Pin Description
1,2 TE+
3,4 TE-
5,6 Ground
7 Sensor+
8 Sensor-

Table 4 - TEC Connector Pintouts

47