Lock; Rcount - Keithley 2700 Service Manual

:LOCK

(:CALibration:PROTected:CARD1:LOCK)
Purpose
Format
Parameter
Description
Example
:LOCK?
(:CALibration:PROTected:CARD1:LOCK?)
Purpose
Format
Response
Description
Example

:RCOunt

(:CALibration:PROTected:CARD1:RCOunt)
Purpose
Format
Parameter
Description
Example
To lock out Model 7700 calibration.
:cal:prot:card1:lock
None
The :LOCK command allows you to lock out Model 7700 calibration after
completing the procedure. Thus, :LOCK performs the opposite of enabling
calibration with the :CODE command.
:CAL:PROT:CARD1:LOCK
To read Model 7700 calibration lock status.
:cal:prot:card1:lock?
0 Calibration locked.
1 Calibration unlocked.
The :LOCK? query requests status from the Model 2700 on Model 7700
calibration locked/unlocked state. Calibration must be enabled sending the
:CODE command before calibration can be performed.
:CAL:PROT:CARD1:LOCK?
To reset card calibration count to 0.
:cal:prot:card1:rco
None
The :RCOunt command resets the card calibration count reported by
:COUNt? to 0.
:CAL:PROT:CARD1:RCO
Calibration Reference
Lock out card 1 calibration.
Request card 1 cal lock state.
Rest card calibration count.
B-19