Cisco WAP200 Administration Manual page 68

Configuring the WAP200 Access Point
Configuring Administration Settings
STEP 3
Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and Rangebooster
- (SNMP v3 only) Privacy Password—Enter the privacy password for
data encryption to monitor administrator traffic. Minimum password
length is 8 characters.
- Get Community—Enter the password that allows read-only access to
the access point's SNMP information.
- Set Community—Enter the password that allows read/ write access to
the access point's SNMP information.
- SNMP Trap-Community—Enter the password required by the remote
host computer that receives trap messages or notices sent by the
access point.
- SNMP Trusted Host—Enter the IP address of the host trusted with
accessing the access point's SNMP information. If this field is set to
0.0.0.0, then access point will response to SNMP message from every
host within the LAN.
- SNMP Trap-Destination—Enter the IP address of the remote host
computer that receives the trap messages.
Click Save.
6
62