Chapter 6: Configuring The Wap200 Access Point - Cisco WAP200 Administration Manual

Configuring the WAP200 Access Point
Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and Rangebooster
This chapter describes how to configure your Cisco WAP200 Wireless-G Access
Point with Power Over Ethernet and Rangebooster using the web-based
configuration utility. Configuration is not required if you wish to use the access
point right out of the box with its default settings.
This chapter includes the following sections:
• Setting Up Your Access Point, page 20
• Configuring Wireless Settings, page 24
• Configuring the Access Point's Modes of Operation, page 50
• Configuring Security Monitor Settings, page 55
• Configuring Administration Settings, page 59
• Verifying Access Point Status, page 69
• Using Windows Help Menus, page 74
6
19