Inspire LEG PRESS 2 OPTION Assembly & Operation Manual page 18

Cable
Cable End
w/ Bushing
Step 3: Attach Pulleys 1 & 2 to Press Arms using:
Step 4: Attach Pulleys 3 & 4 to Leg Press Base using:
Step 5: Attach Pulleys 5 & 6 to Pulley Bracket using:
Step 6: Attach Pulley 7 to Floating Pulley Bracket using: One (3 ½" Pulley)
Step 7: Attach Main Cable by sliding end of cable thru slot of Cable End as shown,
then slide Bushing into Cable End, attach Bolt. Route the Main Cable around
Pulleys 1, 3, 5 and thru Floating Pulley 7, continue routing cable around Pulleys 6,
4, 2 and attach other end of cable to Cable End using:
STEP 5
2 – 3 ½" Pulleys
2 – 2" Hex Bolts
4 – 3/8" Flat Washers
2 – 3/8" Lock Nuts
Pulley-5 & 6
STEP 7
1 – 8" Hex Bolt
2 – 3/8" Small OD
Washers
1 – 3/8" Lock Nuts
(Wrench Tighten Bolts)
(Wrench Tighten Bolts)
(Wrench Tighten Bolts)
(Wrench Tighten Bolts)
(Wrench Tighten Bolts)
Pulley-1 & 2 Pulley-3 & 4
STEP 3
2 – 3 ½" Pulleys
2 – 2" Hex Bolts
4 – 3/8" Flat Washers
2 – 3/8" Lock Nuts
Two (3 ½" Pulleys)
Two (3/8" x 2" Hex Bolts)
Four (3/8" Flat Washers)
Two (3/8" Lock Nuts)
Two (3 ½" Pulleys)
Two (3/8" x 1 ¾" Hex Bolts)
Two (3/8" Flat Washers)
Two (3 ½" Pulleys)
Two (3/8" x 2" Hex Bolts)
Four (3/8" Flat Washers)
Two (3/8" Lock Nuts)
One (3/8" x 2" Hex Bolt)
Two (3/8" Flat Washers)
One (3/8" Lock Nut)
One (3/8" x 8" Hex Bolt)
Two (3/8" Small OD Washers)
One (3/8" Lock Nut)
Page 16
STEP 6
1 – 3 ½" Pulley
1 – 2" Hex Bolt
2 – 3/8" Flat Washers
1 – 3/8" Lock Nut
Pulley-7
STEP 4
2 – 3 ½" Pulleys
2 –1 ¾" Hex Bolts
2 – 3/8" Flat Washers