Pitchsft (Pitch Shifter); S.ptcshft (Stereo Pitch Shifter) - Korg R3 Effect Manual

Effect guide
SyncNote (LFO SyncNote)
Sets the LFO frequency as a proportion of the tempo set
by the [TEMPO] knob if "BPM Sync" is On.
☞p.5 "SyncNote (LFO SyncNote)"
LFO Wave (LFO Waveform)
Selects the LFO waveform.
☞p.5 "LFO Wave (LFO Waveform)"
LFOShape (LFO Shape)
Adjusts the shape of the internal LFO waveform.
☞p.5 "LFOShape"
Key Sync (LFO Key Sync)
Specifies whether the LFO will be reset by note-on.
☞p.5 "Key Sync (LFO KeySync)"
IniPhase (LFO Init Phase)
Sets the starting location of the waveform if "Key Sync"
is Timbre.
☞p.5 "IniPhase (LFO Init Phase)"
Pre LPF
This parameter enables you to set the damping amount
of the high range sound input to the ring modulator. If
the input sound contains lots of harmonics, the effect
may sound dirty. In this case, cut a certain amount of
high range.
22
[8/1...1/64]
[Saw, Square, Triangle, Sine, S&H]
[–63...+63]
[Off, Timbre]
[000...180°]
[000...127]
26. PitchSft
(Pitch Shifter)
S.PtcShft
(Stereo Pitch Shifter)
This effect changes the pitch of the input signal. You can
select from three types: Fast (quick response), Medium,
and Slow (preserves tonal quality). You can also create
an effect in which the pitch is gradually raised (or
dropped) using the delay with feedback.
If used for an insert effect, this will be mono-in/mono-
out.
Insert FX
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Input Level
+
Pitch Shifter
Input Level
Right
If used for the master effect, this will be stereo-in/ste-
reo-out.
Master FX
Stereo In - Stereo Out
Left
Pitch Shifter
Trim
Pre
Feedback Position
Pre
Trim
Pitch Shifter
Right
Pitch (Pitch Shift)
Sets the pitch shift amount by steps of a semitone.
Fine
Sets the pitch shift amount by steps of a cent.
BPM Sync (DelayTime BPM Sync)
Specifies whether the delay time will be synchronized.
☞p.13 LCR Delay "BPM Sync (Delay Time BPM Sync)"
only MFX
TimRatio (Time Ratio)
[BPM Sync Off: 000.5...400.0% (OVER)
BPM Sync On: 012.5...400.0% (OVER)]
☞p.13 LCR Delay "TimRatio (Time Ratio)"
only MFX
Delay (Delay Time)
If "BPM Sync" is Off, this delay time is set in msec units.
If "BPM Sync" is On, this delay time is set as a timing
resolution relative to the tempo specified by the [TEM-
PO] knob or MIDI clock.
only MFX
FB Pos (FeedBack Position)
Switches the feedback connection.
only MFX
Feedback
Sets the feedback amount.
Mode
This parameter selects the pitch shifter operating mode.
With Slow, tonal quality will not be changed too much.
With Fast, the effect becomes a Pitch Shifter that has a
quick response, but may change the tone. Medium is in
: IFX
: MFX
Dry / Wet
High Damp
Delay
Dry / Wet
Dry / Wet
High Damp
Delay
Post
Feedback
Post
Delay
High Damp
Dry / Wet
[–24...+24]
[–100...+100]
only MFX
[Off, On]
[BPM Sync Off: 000...500msec
BPM Sync On: 1/64... 1/1]
[Pre, Post]
[000...127]
[Slow, Medium, Fast]