Table of Contents
Advertisement
8. Cabi Sim
(Cabinet Simulator)
This simulates the acoustical character of a guitar amp's
speaker cabinet.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Trim
+
Cabinet Simulator
Right
CabiType (Cabinet Type)
Selects the type of the cabinet.
TWD 1X8: Open-back cabinet with one 8" speaker
TWD 1X12: Open-back cabinet with one 12" speaker,
typically used for blues.
TWD 4X10: Open-back cabinet with four 10" speakers.
BLK 2X10: Open-back cabinet with two 10" speakers.
BLK 2X12: American open-back cabinet with two 12"
speakers.
AC15: Vox open-back cabinet with one 12" "Blue"
speaker.
AC30: Vox open-back cabinet with two 12" "Blue"
speakers.
AD412: VOX AD412 closed-back cabinet with four 12"
speakers.
UK H30: Closed-back classic cabinet with four 30W 12"
speakers
UK T75: Closed-back cabinet with four 75W 12" speak-
ers.
US V30: Closed-back cabinet with four 30W 12" speak-
ers.
Air
Sets the distance between the microphone and the Cab-
inet. Increasing this value will increase the distance.
Trim
Sets the input level.
9. Tube Sim
This effect simulates a two-stage vacuum tube preamp.
You can make individual settings for two vacuum tubes
connected in series. This lets you create the warm sound
Dry / Wet
typical of vacuum tubes.
When used in an insert effect, this will be a mono-in/
mono-out effect.
Dry / Wet
[TWD 1X8...US V30]
When used in the master effect, this will be a stereo-in/
stereo-out effect.
Tu1LoCut (Tube1 Low Cut)
Sets the cutoff frequency for the low cut filter of stage 1.
Tu1HiCut (Tube1 High Cut)
Sets the cutoff frequency for the high cut filter of stage 1.
Tu1 Gain (Tube1 Gain)
[000...127]
Sets the input gain for stage 1.
Tu1 Bias (Tube1 Bias)
Sets the bias voltage for stage 1.
[000...127]
This expresses the effect that changes in vacuum tube
bias have on the distortion of the waveform. Higher set-
tings of this value will produce distortion even at low
gain levels. Since this will also change the overtone
structure, you can use it to control the tonal character.
Tu1 Satu (Tube1 Saturation)
Sets the input/output response for stage 1. With higher
settings of this value, the waveform will change at high
(Tube PreAmp Simulator)
S.TubSim
(Stereo Tube PreAmp Simulator)
IFX
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Phase
+
+
Tube Pre Amp1
–
Right
MFX
Stereo In - Stereo Out
Left
Phase
+
Tube Pre Amp1
–
Phase
+
Tube Pre Amp1
–
Right
Out
Effect parameters
: IFX
: MFX
Dry / Wet
Tube Pre Amp2
Output Level
Dry / Wet
Dry / Wet
Tube Pre Amp2
Output Level
Tube Pre Amp2
Output Level
Dry / Wet
[000...127]
[000...127]
[–Inf, –40...+24dB]
[000...100%]
Bias
Bias = 100
Bias = 50
Bias = 0
In
Satulation = 50
[000...100%]
9
Advertisement
Table of Contents
