AUXILIARY EQUIPMENT DRIVE BELT for «STOP AND START»
C3
Engine: KFU
Tools.
[1] Compression tool
: 4388-T
IMPERATIVE: Respect the precautions to be taken prior to any operation.
Checking the «stop and start» accessories belt.
Checking the belt extension.
Disconnect the battery.
Using a vernier gauge, measure the extension of the tensioner.
The length «X» should be between 77.6 mm and 85.6 mm.
Replace the accessories belt if the extension value is greater than 85.6 mm.
Visual checking of the belt.
Remove the accessories belt, using tool [1] (see corresponding operation) .
Carefully twist the belt to check that there is no cracking or splitting, whether on the back of the belt or
in the notches.
B1EP1J6C
82