CITROEN C2 Handbook page 115

C2 - C3 - C3 PLURIEL
CHECKING AND SETTING THE VALVE TIMING
Engines: 8HX - 8HZ
Checking the setting (continued).
Remove:
- The accessories drive belt.
- The accessories drive pulley.
- The lower timing cover (3).
IMPERATIVE: The magnetic track should show no signs of
damage and should not be approached by any other source of
magnetism.
Reposition the screw (2).
Remove tool [3].
Rotate the engine by means of the crankshaft pinion screw (2) (clockwi-
se) to bring it to the pegging position.
Position the tool [4].
Peg the crankshaft pinion (1), using tool [5].
Peg the high pressure pump pinion, using tool [5].
NOTE: Index «a» of the roller tensioner must be centred within the area
«b».
Check the correct positioning of index «a».
Remove tools [4] and [5].
Rotate the engine ten times.
Fit the tools [4] and [5].
If pegging is not possible, carry out the operation to remove/refit the
timing belt (see corresponding operation) .
B1JP03SC B1EP18DC B1EP18EC B1EP18FC
109