CITROEN C2 Handbook page 129

C3
CHECKING AND SETTING THE VALVE TIMING
Engine: 8HY
Setting the timing (continued).
Checks (continued).
Reposition the timing belt, belt at «e» well tensioned, in the following order:
- Guide roller (17).
- Camshaft pulley (16).
- Fuel high pressure pump pulley (15).
- Coolant pump pinion (18).
- Tensioner roller (19).
Remove the 5 mm diameter peg at «d».
Adjusting the fitting tension of the belt.
Action the tensioner roller (19) to align the marks «f» and «g», avoiding detensioning the timing belt,
with the aid of a male hexagonal spanner at «c».
If this is not successful, repeat the operation to tension the belt.
Hold the tensioner roller in position (19).
Tighten the tensioner roller, tightening to 3,7 ± 0,3 m.daN.
Check the position of the tensioner roller (the alignment of the marks «f» and «g» should be correct) .
Remove tools [2] and [3].
Turn the crankshaft six rotations (clockwise) .
B1EP18XC
123