CITROEN C2 Handbook page 249

BLEEDING AND FILLING THE BRAKING SYSTEM C3 - C3 PLURIEL
Bleeding, filling (continued).
With the bleeding apparatus.
Connect the bleeding apparatus [1] on the brake fluid reservoir (1).
Adjust the apparatus pressure to 2 bars.
For each circuit:
- Connect a transparent tube onto the bleed screw, submerge the other end of the tube in a clean container.
- Open the bleed screw, wait until the fluid is flowing out without air bubbles.
- Close the bleed screw.
- Remove the bleeding apparatus [1].
- Check the brake fluid level (should be between «MINI» level and «MAXI» level) .
- Fill if necessary with the approved and recommended synthetic brake fluid.
Without the bleeding apparatus.
NOTE: Two operators are necessary.
For each circuit:
- Apply the brake pedal to place the circuit under pressure.
- Connect a transparent tube onto the bleed screw, submerge the other end of the tube in a clean container.
- Open the bleed screw, wait until the fluid is flowing out without air bubbles.
- Close the bleed screw.
- Remove the tool [1].
NOTE: Recommence the process a second time if that is necessary.
- Check the brake fluid level (should be between «MINI» level and «MAXI» level) .
- Fill if necessary with the approved and recommended synthetic brake fluid.
B3FP160C
243