Draining of the engine lubrication system by GRAVITY
Place the vehicle on horizontal ground (in the high position if
hydropneumatic suspension) .
The engine should be hot (oil temperature 80°C) .
Drain the sump by gravity.
Remove the oil filter cartridge (time for draining and drip-drip =
15 minutes approx.) .
Refit the cap with a new seal.
Refit a new oil filter cartridge.
Refill the engine with oil (see table for oil capacity) .
Start the engine to fill the oil filter cartridge.
Stop the engine (allow to stabilise for 5 minutes) .
CAPACITIES (in litres)
Draining methods
Oil capacities are defined according to the following methods
ESSENTIAL: Systematically check the oil level using the oil dipstick.
Draining of the engine lubrication system by SUCTION
Place the vehicle on horizontal ground (in the high position if
hydropneumatic suspension) .
The engine should be hot (oil temperature 80°C) .
Remove the oil by suction through the dipstick tube.
Remove the oil filter cartridge.
Maintain the suction of oil in the sump (15 minutes approx.) .
Refit a new oil filter cartridge.
Refill the engine with oil (see table for oil capacity) .
Start the engine to fill the oil filter cartridge.
Stop the engine (allow to stabilise for 5 minutes) .
WARNING: Remove the suction container before
starting the engine
10