Configuring For Camera Masking; Configuring Alarms; Configuring Local Alarms; Figure 5-43 Camera Masking Configuration Interface - Honeywell HEN04111 User Manual

184 | Embedded Network Video Recorder User Guide

Configuring for Camera Masking

You can configure the system to generate a camera masking alarm when the minimum amount
of masking (as defined by you) is detected in the video.
Click Camera Masking in the Event configuration interface to open the Camera Masking
configuration interface.
The configuration for Camera Masking Detection is very similar to the configuration for Motion
Detection. Please see

Configuring Alarms

Before configuring alarms, ensure that you have properly connected alarm devices such as a
buzzer. You can configure local and network alarms.
Click Alarm in the Event configuration interface to open the Alarm configuration interface.

Configuring Local Alarms

Click Local Alarm in the Alarm configuration interface to open the Local Alarm configuration
interface.
www.honeywell.com/security
Figure 5-43 Camera Masking Configuration Interface
Configuring for Motion Detection on page 179 for more information.