Figure 3-20 Network Test Tab - Honeywell HEN04111 User Manual

58 | Embedded Network Video Recorder User Guide
Network Test Tab
Network Test
1.
2.
Network Sniffer Packet Backup
1.
2.
3.
4.
While the Sniffer is working in the background, you can perform other network operations, such
as logging into the Web and monitoring. Click
interface. The NVR/system will save the packets to the specified path. The file name is Network
adapter name+time.
Opening the Packets
a professional engineer can solve the problem.
www.honeywell.com/security
Figure 3-20 Network Test Tab
Enter an IP address in the Destination Ad field.
Click Test.
The test results will show if the network connection is good, as well as the average delay
and packet loss rate.
Insert a USB 2.0 device into the USB port on the front panel of your NVR. See
on page 29.
Click Refresh, then find your USB 2.0 device in the Device Name field. See
You might need to use the drop-down menu to find your device.
Click Browse to select the save path.
Click the Begin Sniffer button
All connected adapter names appear in the found network adapters table. Adapter names
can include Ethernet, PPPoE, WIFI, and 3G.
To stop the Sniffer, click the gray Stop button.
Note You can not Sniff several network adapters at the same time.
Use software such as Wireshark to open the packets on the PC so that
in the column on the right to start the Sniffer.
to stop the Sniffer and return to the Sniffer
Enter
the IP
address
Figure Note
Figure 3-20.