Honeywell HEN04111 User Manual page 182

182 | Embedded Network Video Recorder User Guide
www.honeywell.com/security
Table 5-19
Configuration
PTZ Activation
Tour
Snapshot
Motion Detection Configurations
Description
When PTZ activation is configured, the system can activate
PTZ operation when an alarm is detected.
1. Click Set to open the PTZ Activation configuration
interface.
2. Select a preset, tour, or pattern from the drop-down menu.
3. Click Save.
Click to enable a tour to be triggered by an alarm. The system
supports 1/8-window tour. See
on page 203 for tour interval setup. On the Display Settings
tab, when there are two tours enabled by default, you can
configure the system so an alarm triggers the system to
enable the alarm tours you configured here. If there is no
alarm, then the system uses the tour setup that was
configured in the Display interface.
1. Click Setup to select a tour channel. The system begins a
1-window or multiple-window tour display showing the
channels you've set to record when an alarm occurs.
2. Click to select a channel, or All, then click Save.
Click to enable the Snapshot function. A snapshot will be
taken when an alarm occurs.
1. Click Set to open the Snapshot Configuration interface.
2. Click to select a channel, or All, then click Save.
Configuring Display Settings