Configuring The Network; Figure 3-27 Network Interface - Honeywell HEN04111 User Manual

70 | Embedded Network Video Recorder User Guide
Click Save to save the new configuration. The NVR will return to the previous menu.

Configuring the Network

Click the Network icon
interface.
IPv4
www.honeywell.com/security
in the Setting interface to open the Network configuration
Figure 3-27 Network Interface
Table 3-12 Network Configurations
Parameter
IP Version
MAC Address
IP Address
Subnet Prefix
Default Gateway
Function
Select either IPv4 or IPv6. Both formats are supported.
Each NVR gets a unique MAC address. You can use the MAC
address to connect to the NVR in the LAN. The MAC address
is not configurable; it is read-only.
Use the Up/Down arrows (
use the keyboard to enter an IP address. Then configure the
corresponding subnet mask for the default gateway.
Select from 0 to 128. Used to mark a specified network MAC
address.
Enter the default gateway.
Note The system needs to check the validity of all IPv6
addresses. The IP address and the default gateway
must be in the same IP section. The specified length of
the subnet prefix must have the same string.
IPv6
 
/ ) to select an IP address, or