Honeywell HEN04111 User Manual page 181

Table 5-19
Configuration
Region
Record Channel
Delay
Alarm Out
Latch
Motion Detection Configurations
Description
1. Select a motion detection type.
2. Click Set. The Motion Detection Set configuration
interface appears.
3. Select the event detection area by left-clicking and
dragging the mouse.
There are 396 (PAL) or 330 (NTSC) small zones.
Green: Indicates the current cursor position.
Grey: Indicates the event detection zone.
Black: Indicates a disarmed zone.
Note Use the FN button on the NVR's front panel to switch
the cursor between selecting and deselecting.
Note When the alarm is armed, you can use the directional
buttons on the NVR to move the green motion
detection rectangle.
4. Click Save to save the configurations. Click Esc to exit the
setup without saving the changes.
The system automatically starts recording selected channels
when a motion detection alarm occurs.
Note You need to set the motion detection recording period.

Go to Storage Schedule to configure the current channel
for scheduled recording. See
Schedules on page 192.
The system can delay recording for a specified amount of time
after an alarm has ended. Select from 10s to 300s.
Select the device output port, from 1 to 3. Select the
corresponding port(s) so the system can activate the
corresponding alarm devices when an alarm occurs.
The system can delay the alarm output for a specified time
after an alarm ends. The value ranges from 1s to 300s.
Web Operation | 181
Configuring Local Storage for
800-18160 - A - 06/2014