Honeywell HEN04111 User Manual page 94

94 | Embedded Network Video Recorder User Guide
How to Record
1.
2.
3.
4.
www.honeywell.com/security
Table 3-22 Alarm Configurations
Parameter
PTZ Activation
Delay
Tour
Snapshot
Buzzer
Note You must click Save after configuring the settings to save them.
In the Record interface, set the alarm record mode to Schedule.

Go to Main Menu Advanced
Note If you select Manual recording, that mode has the highest priority. So the system
will record all the time instead of because of an alarm trigger.
Set the recording type, corresponding channel, week, and date.

• Go to Main Menu Setting
• For the recording type, select from Regular, MD, Alarm, MD&Alarm.
Note You can not select MD&Alarm and MD (or Alarm) at the same time.
Set the alarm record and encoder parameters.

• Go to Main Menu Setting
Set the alarm input as the local alarm, and then select the recording channel. The NVR will
record this channel when an alarm is detected.
Description
When PTZ activation is configured, the system can activate
PTZ operation when an alarm is detected. The PTZ activation
lasts the anti-dither period.
See Configuring PTZ Activation on page
The system can delay recording for a specified amount of time
after an alarm has ended. Select from 10s to 300s.
Click to enable a tour to be triggered by an alarm. The system
supports 1/8-window tour. Go
on page 110 for tour interval setup.
Note Tours setup here have higher priority than tours setup
in the Display interface. If there is no alarm, the system
implements the tour setup in the Display interface.
Click to enable the Snapshot function. A snapshot will be
taken when an alarm occurs.
Click to enable the Buzzer function. The buzzer beeps when
an alarm occurs.

Record.

Schedule.

Encode.
95.
toConfiguring Display Settings