Configuring Net Alarms; Figure 5-45 Net Alarm Configuration Interface - Honeywell HEN04111 User Manual

Table 5-20 Local Alarm Configurations
Configuration
Snapshot
Show Message
Send Email
Buzzer

Configuring Net Alarms

Configure Network Alarms so that the NVR can detect alarm signals from the network. The
system does not support anti-dither and sensor type setup.
Click Net Alarm in the Alarm configuration interface to open the Net Alarm configuration
interface.
Figure 5-45 Net Alarm Configuration Interface
Description
Click to enable the Snapshot function. A snapshot will be
taken when an alarm occurs.
1. Click Set to open the Snapshot Configuration interface.
2. Click to select a channel, or All, then click Save.
Click to enable a pop-up message on your local host PC
screen to let you know an alarm has occurred.
The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system
can also send an image attached to the email. Go to Main
 
Menu Setting Network
settings. See Configuring Email Settings on page
Click to enable the Buzzer function. When an alarm occurs,
the buzzer beeps.
Web Operation | 187

Email to configure the email
173.
800-18160 - A - 06/2014