Chapter 3 Hardware Overview
3.3 Rear Panel
The following figures show the rear panels of the AC power input model switch. The rear
panel contains a connector for the power receptacle.
Figure 13 Rear Panel - AC Model
3.3.1 Power Connector
Make sure you are using the correct power source as shown on the panel.
To connect the power to the switch, insert the female end of power cord to the power
receptacle on the rear panel. Connect the other end of the supplied power cord to a 100~240V
AC, 1.5A power outlet.
3.4 LEDs
The following table describes the LEDs.
Table 2 LEDs
LED
PWR
10/100 Mbps Ethernet Ports
LNK/ACT
FDX/COL
Gigabit Ethernet Ports
100/1000
ACT
38
COLOR
STATUS
DESCRIPTION
Green
On
The system is turned on.
Off
The system is off.
Amber
Blinking
The system is transmitting/receiving to/from a 10/100 Mbps
Ethernet network.
On
The link to a 10/100 Mbps Ethernet network is up.
Off
The link to an Ethernet network is down.
Amber
On
The Ethernet port is negotiating in full-duplex mode.
Blinking
The switch is detecting collisions on the Ethernet port.
Off
The Ethernet port is negotiating in half-duplex mode.
Green
On
The link to a 10/1000 Mbps Ethernet network is up.
Amber
On
The link to a 100 Mbps Ethernet network is up.
Off
The link to an Ethernet network is down.
Green
On
The link to an Ethernet network is up.
Blinking
The Ethernet port is transmitting/receiving data.
Off
The link to an Ethernet network is down.
ES-1528 User's Guide