Figure 85 Viewing ARP Table Entries
The following table describes the labels in this screen.
Table 66 ARP Table
LABEL
Static MAC-IP
binding: ADD
Item
MAC Address
IP Address
VLAN
Type
DELETE
20.4 Adding ARP Table Entries
Click ADD in the Dynamic ARP > ARP Entries screen to open the Add Static MAC-IP
binding screen. Use this screen to add entries to the ARP table.
You must first enable dynamic ARP in the Dynamic ARP > Settings screen
before you can add static ARP table entries.
Figure 86 Viewing ARP Table Entries
ES-1528 User's Guide
DESCRIPTION
This field is only available when you enable dynamic ARP in the Dynamic ARP >
Settings screen. Click ADD to add a static entry to the ARP table. See
on page
135.
This is the ARP table entry number.
This is the MAC address of the device connected to the switch with the corresponding
IP address below.
This is the learned IP address of a device connected to a switch port with
corresponding MAC address above.
This is the VLAN number of the device connected to the switch.
This shows whether the MAC address is dynamic (learned by the switch) or static
(manually entered in the Add Static MAC-IP binding screen).
Click this to remove this ARP table entry.
Chapter 20 Dynamic ARP
Section 20.4
135