Removing/Reinstalling Plug-In Boards; Dcp/Dvp Board Assembly; Board - Sony DIGITAL BETACAM DVW-707 Maintenance Manual

1-9. Removing/Reinstalling Plug-in Boards

Be careful not to damage the board and to position and
orient the board correctly when removing/reinstalling the
plug-in boards.

1-9-1. DCP/DVP Board Assembly

m
. When replacing the board, set the switches on the new

board.

DCP-17 board : Refer to Section 1-10-3.
DVP-17 board : Refer to Section 1-10-4.
. After replacing the board, see the Maintenance Manual
Part 2 Vol.1 and perform adjustments as follows :
DCP-17 board : Sec. 7. Camera System Electrical
Alignment
DVP-17 board : Sec. 6-5. Video System Adjustment
(Automatic Equalizer Adjustment and
REC Current Adjustment)
Removing
1. Open the inside panel. (Refer to Section 1-7.)
2. Remove the harnesses from the connectors CN12 and
CN13 on the DCP board assembly.
3. Open the levers to disconnect the DCP or DVP board
assembly from the connectors on the MB-810 board.
4. Lift the DCP or DVP board assembly out.
Levers
CN12
CN13
DVP board
assembly
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P1
Reinstalling
1. Stay opens the levers of the board in advance.
2. Insert the DCP or DVP board assembly along the
3. After the shafts of levers get into the chassis, close the
4. Reconnect the harnesses to the connectors CN12 and
1-9-2. SV-210 Board
1. Open the inside panel. (Refer to Section 1-7.)
2. Grasp the board by the pull ring and pull it out to
SV-210 board
DCP board
assembly
MB-810
board
Inside panel
1-9. Removing/Reinstalling Plug-in Boards
board guide rails.
levers and press in the board to firmly connect it to the
connector of the MB-810 board.
CN13 on the DCP board assembly.
disconnect the SV-210 board from the connectors of
MB-811 board.
Pull ring
MB-811 board
1-17