Bkdw-703 (My-93 Board) - Sony DIGITAL BETACAM DVW-707 Maintenance Manual

9-2. BKDW-703 (MY-93 board)

9-2. BKDW-703 (MY-93 board)
Install the BKDW-703 on side B of the DVP-17 board.
Procedure
1. Open the inside panel. (Refer to Section 1-7.)
2. Remove the DVP board assembly. (Refer to Section 1-
9.)
3. Remove the shaft cap and the support shaft (long)
from the DVP board assembly.
4. Hold the cap of the board support with tweezers and
press it to shrink. Remove the four caps from the four
board openings, and then remove the DVP-14 board.
DVP-17 board
Support shaft (long)
Board supports
9-2
DVP board assembly
(slot in the deep end)
Inside panel
Board opening
Board support
DVP-14 board
Shaft cap (red)
5. Attach the two supports (5) supplied, onto side B of
the DVP-17 board with the two precision screws
supplied.
Studs (5)
(supplied accessory)
6. Insert the connector of the BKDW-703 (MY-93 board)
to CN7 and CN8 on side B of the DVP-17 board, and
connect them firmly.
7. Use the two precision screws supplied and fasten the
BKDW-703 on the supports (5) attached in step 5.
8. Install the supplied support shaft (short) and the shaft
cap as shown in the figure.
DVP-17 board
CN8
Support
shaft
(short :
supplied
accessory)
CN7
DVP-17 board
Precision P 1.4x3.5
(supplied accessory)
Supports (5)
BKDW-703
Precision P 1.4x3.5
(supplied accessory)
Shaft cap
(supplied accessory)
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P1