Ceramic Fuel Bed Installation - Valor RetroFire RF24DN Installation And Owner's Manual

Top Convection Baffle Installation
Position the firebox as far back as possible within the existing fireplace to allow ample space at front for the fret
and to allow convection air to flow under the smoke curtain of the existing fireplace. Position the top convection
baffle with the threaded studs pointing downwards into the slots at the top of the firebox. Slide the convection baffle
as far forward as possible, angled down if possible, to force the air under the smoke curtain, and tighten the wing
nuts.
Wingnuts (2)
Ceramic Brick Liner Installation
Install the ceramic brick liner taking care not to damage them as the material is fragile. The top rounded edges of
the side panels should face inwards and the front edge bevelled. Place the side brick panels flat against the side of
the firebox up high and slide downward into place behind the front return edge on the firebox.
Side Brick in front of Rear Brick
Left
Brick
Side Brick Behind
2
Firebox Return
Firebox Installation

Ceramic Fuel Bed Installation

1
Rear Brick
Start wingnuts on studs. Slide
Convection Baffle into slots.
Adjust Baffle Forward to Touch
Back of Smoke Curtain of
Existing Fireplace. Tighten
Wingnuts.
Rear Brick
Rest Brick on
Rear Log Support
Left
Brick
3
Rear Brick
Right
Brick
15