Window Refitting And Checking; Remote Control Installation - Valor RetroFire RF24DN Installation And Owner's Manual

Direct vent fireplace insert

Hide thumbs

Table Of Contents

Table of Contents

Hook the window over the top edge of the firebox, and

fasten the bottom two spring loaded bolts by pushing

in and turning 90 degrees. Check that the window

moves freely against the spring by pulling out at the

bottom. If broken, the window may only be replaced as

a complete unit as supplied by the manufacturer.

Note: To remove the window, the cast iron fret and

fret retainers will need to be removed first—see

section Cast Iron Fret Installation.

CAUTION

DO NOT PUT BATTERIES IN THE REMOTE

CONTROL RECEIVER until the wires are

connected to the burner control unit as short-

circuit could result in the destruction of the

electrical components.

1. Connect the wiring harness to the receiver box, by

pushing the wire connector on to the receiver circuit

board. The plug will only go on one way so please

ensure that the wires are pointing up and slot in the

board is in line with the tab on the wiring harness

plug.

2. Connect wires as shown. Please note that the "L"

connectors are different sizes, the smaller one fits

to the lower connection and the larger one the top

connection on the top left hand side of the valve.

The other two wire connectors can be fitted to either

terminal located to the left of the flame control

button.

3. Remove the remote control receiver lid.

4. Fit four AA 1.5 V alkaline batteries.

5. Place the remote control receiver on the base of

the fireplace beside the valve.

6. Fit the 9 V alkaline battery to the handset

transmitter.

Remote control operating instructions are on

pages 20–21 of this manual.