Operation; Your First Fire; Pilot And Burner Inspection; Flame & Temperature Adjustment - Vermont Castings Intrepid INDVRCB Homeowner's Installation And Operating Manual

Intrepid® Direct Vent - Rear Vent Gas Heater
4. Install top log by mating hole on
bottom of log with locating pin
on top right side of rear log. (Fig.
61) Position log so it is angled
down toward the area where the
front two logs meet.
The Intrepid is operated with the operable door front
plate in place with the doors open or closed. To open
the front doors, pull either door toward you.

Your First Fire

Read these instructions carefully and familiarize
yourself with the burner controls shown in Figure 62.
Locate the pilot assembly, Figure 63. Follow the lighting
instructions on Page 32 exactly.
During the first fire, it is not unusual to smell some
odor associated with new logs, paint and metal being
heated. Odors should dissipate within a few hours. You
can open a window to provide fresh air to alleviate the
condition.
Manifold Pressure Tap
Pilot Adjustment
Screw
Fig. 62 NOVA SIT valve control.
30
Left Log

Operation

Inlet Pressure Tap
Gas Control
Regulator
Knob
Control Knob
ST941
Figure 61
Ember Bed
Fig. 63 Pilot Assembly location.

Pilot and Burner Inspection

Each time you light your heater check that the pilot
flame and burner flame pattern are as shown in Figure
65. If flame patterns are incorrect, turn the heater off.
Contact your dealer or a qualified gas technician for as-
sistance. Do not operate the heater until the pilot flame
is correct.
Follow regular maintenance procedures as described
on Page 37.
Flame & Temperature Adjustment
For stoves equipped with HI/LO valves, flame adjust-
ment is accomplished by rotating the HI/LO adjustment
knob located near the center of the gas control valve.
(Fig. 64)
Top Log
Back Log
Right Log
Pilot Assembly
ST935
SDDVT
pilot location
6/07
LG499
ST935
20012761