Vermont Castings Radiance RUVSOD 3370 Homeowner's Installation And Operating Manual
Vent free gas heater
Hide thumbs
Also See for Radiance RUVSOD 3370:
- Installation and operating manual (28 pages) ,
- Homeowner's installation & operating manual (28 pages) ,
- Homeowner's installation and operating manual (28 pages)
Table of Contents
Advertisement
INSTALLER / CONSUMER
SAFETY INFORMATION
Please read this manual before
installing and using appliance.
WARNING: If the information in this
manual is not followed exactly, a fire
or explosion may result causing
property damage, personal injury or
loss of life.
—Do not store or use gasoline or
other flammable vapors and
liquids in the vicinity of this or
any other appliance.
—WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appli-
ance.
• Do not touch any electrical
switch; do not use any phone
in your building.
• Immediately call your gas
suppler from a neighbor's
phone. Follow the gas
suppler's instructions.
• If you cannot reach your gas
supplier, call the fire depart-
ment.
Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
This is an unvented gas-fired heater.
It uses air (Oxygen) from the room
in which it is installed. Provisions for
adequate combustion and
ventilation air must be provided.
Refer to Page 7.
INSTALLER: DO NOT DISCARD THIS MANUAL - LEAVE FOR HOMEOWNER
Radiance
Vent Free Gas Heater
Model RUVSOD: 3370 thru 3379
Vermont Castings, Majestic Products
410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 • 905-670-7885
www.majesticproducts.com • www.vermontcastings.com
Homeowner's Installation
and Operating Manual
4555
20004555 8/03 Rev. 8
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Vermont Castings Radiance RUVSOD 3370
Summary of Contents for Vermont Castings Radiance RUVSOD 3370
- Page 1 Vermont Castings, Majestic Products INSTALLER: DO NOT DISCARD THIS MANUAL - LEAVE FOR HOMEOWNER Radiance Vent Free Gas Heater Model RUVSOD: 3370 thru 3379 Homeowner’s Installation and Operating Manual 410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 • 905-670-7885 www.majesticproducts.com •...
-
Page 2: Table Of Contents
Vermont Castings Radiance Vent-Free Gas Heater PLEASE READ THE INSTALLATION & OPERATING INSTRUCTIONS BEFORE USING APPLIANCE. Thank you and congratulations on your purchase of a Vermont Castings stove. IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty. -
Page 3: Installation And Operating Instructions
Installation & Operating Instructions In order to ensure safe and effective installation, this unit must be installed only by a qualified agency, individual, firm, corporation or company that is experienced in the installa- tion, repair and servicing of this type of appliance and is familiar with the building codes and installation techniques appropriate in your area. -
Page 4: Stove Dimensions
Vermont Castings Radiance Vent-Free Gas Heater Radiance Vent Free Gas Heater Dimensions 29 " (756mm) R A D I A N C E 28 " (717mm) 6 " Supply Inlet (165mm) 11" (279mm) 31" (787mm) 18 " (465mm) Drawing Not to Scale 4555 Fig. -
Page 5: Clearance Requirements
Clearance Requirements Minimum Clearances to Combustible Materials Maintain clearance, (empty space), between combus- tible materials and the heater as specified below. A: To Side Wall / Trim* ... 4" (101.6mm) B: To Rear Wall ... 4" (101.6mm) Alcove Clearances A: Maximum Alcove Depth ... 24" (609mm) B: To Side Wall ... -
Page 6: Gas Specifications
Vermont Castings Radiance Vent-Free Gas Heater Gas Specifications Model Fuel Gas Control RUVSODRN Nat. Millivolt RUVSODRP Prop Millivolt Firebox weight / shipping 175 lbs. Gas Inlet and Manifold Pressures Natural Inlet Minimum 5.5” w.c. Inlet Maximum 14” w.c. Manifold Pressure 3.5”... -
Page 7: Vent Free Features
Vent Free Features The Radiance RUVSOD, Model Nos. 3370 thru 3379, is an unvented gas heating appliance tested and listed to the ANSI standard Z21.11.2-2000. This appliance is specifically configured to burn either Natural Gas or Propane fuel, as indicated on the metal rating plate attached to the rear shroud. - Page 8 Vermont Castings Radiance Vent-Free Gas Heater with a volume of 1152 cubic feet. The total space volume is 3840 cubic feet. (1728 + 960 + 1152). 2. Divide the volume of space by 50 cubic feet. The result is the maximum BTU/Hr that the space can support.
-
Page 9: Assembly Procedures
Read these instructions thoroughly before starting the assembly. Follow procedures in the order given. Inspect the stove for damage before starting the assembly. Do not install this stove if any damage is evident. Contact your dealer immedi- ately. The Radiance is shipped on its back, mounted to a wooden pallet. -
Page 10: Assemble Legs
Vermont Castings Radiance Vent-Free Gas Heater Assemble the Legs 1. Slide stove to the rear of the pallet just far enough to access rear leg holes. Make sure the stove does not tip over backwards. (Fig. 7) Fig. 7 Slide stove back just far enough to access rear leg holes. - Page 11 4. Attach the fan assembly to the fan bracket provided in the log box. Use #10 sheet metal screws provided with fan kit. Do not remove finger guard screws.(Fig. Snapstat Wire ST669 Fig. 10 Attach the fan assembly to the fan bracket. 5.
-
Page 12: Install On/Off Switch
Vermont Castings Radiance Vent-Free Gas Heater Rheostat Retaining Nut Control Knob Fig. 14 Attach rheostat to control panel. Valve may look different. Disconnect power MOTOR before servicing. ON/OFF RHEOSTAT POWER Fig. 15 #2767 / FK26 Fan Wiring Diagram WARNING The optional fan kit is equipped with a three- prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong outlet. -
Page 13: Glass & Catalyst Installation
On/Off Switch Wiring TP/TH Black Optional Thermostat Wiring TP/TH Black Glass & Catalyst Installation CAUTION: Air shutter must be removed when installing glass and catalyst for proper operation. 1. Remove left and right log bracket assembly by unfastening the two screws which hold the burner in place. -
Page 14: Connect The Gas Supply Line
Vermont Castings Radiance Vent-Free Gas Heater 8. Install glass frame assembly by resting the bottom edge of the frame on support brackets below the front opening of the firebox. Swing the top edge of the assembly toward the firebox, and center it. Fasten by closing the latches over the top left and right edges of the frame. -
Page 15: Complete The Installation
Right Log Right Rear Log Left Rear Log Left Decorative Bracket Grate LG171 Fig. 23 Install the left and right rear logs and the right log. Log rests on Lava Rock decorative grate Fig. 24 Completed log installation. 5. Loosely sprinkle the lava rocks directly on top of the burner just behind decorative grate. -
Page 16: Operation
Vermont Castings Radiance Vent-Free Gas Heater The Radiance is shipped with the operable door front plate. The stove may be operated with the doors either open or closed. To open the front doors, insert the handle provided into the door latch stub and turn it to the right and up. -
Page 17: For Your Safety Read Before Lighting
Lighting And Operating Instructions FOR YOUR SAFETY READ BEFORE LIGHTING WARNING:If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This heater has a pilot which must be lit manu- ally. -
Page 18: Troubleshooting
Vermont Castings Radiance Vent-Free Gas Heater Follow these procedures in the order presented. CONDITION No spark at pilot when Ignitor is operated. The Ignitor Electrode sparks, but Pilot does not light. Piezo Ignitor Regulator HV104 Fig. 34 Honeywell valve assembly. Troubleshooting W A R N I N G TURN OFF HEATER AND ALLOW TO COOL... - Page 19 Troubleshooting cont’d. CONDITION Pilot lights but flame goes out when Control Knob is released. Pilot flame is lifting. Thermopile Thermo- couple ST121a Pilot flame is weak - does not touch Thermocouple. Correct LP Pilot Flame. Pilot lights but Main Burner does not.
-
Page 20: Maintenance
Vermont Castings Radiance Vent-Free Gas Heater The following procedures will help ensure that your heater continues to perform safely and efficiently. Firebox Cleaning and Inspection Cleanliness is critical to correct operation of the heater. The log set, burner, valve controls and air circulation areas must all be kept free of dust and unobstructed by debris. -
Page 21: Catalytic Combustor
Catalytic Combustor The combustor should be cleaned annually to ensure optimal performance. Follow the procedure below. Remove the Combustor Module 1. Be sure the heater is COLD. 2. Remove the front plate, top grille and screen. (Fig. 36) 3. Use the phillips screwdriver to remove the two sheet metal screws that secure the combustor to the top of the firebox. -
Page 22: Replacement Parts
Vermont Castings, Majestic Products reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. Radiance Vent Free Gas Heater (RUVSOD) Models 3370 thru 3379 Ref. Description Gas Logset - RUVSOD... - Page 23 Radiance Vent Free Gas Heater (RUVSOD) Models 3370 thru 3379 (continued) Ref. Description Trim ON/OFF Switch Handle Package, Ceramic w/Screw Damper Steel Handle/Screw 10a. Valve NG Honeywell - VS84212003 10b. Valve LP Honeywell - VS84212011 11a. Oxygenerator, NG OP #8204 11b.
-
Page 24: Optional Accessories
Vermont Castings Radiance Vent-Free Gas Heater Fan Kits FK26 Fan The FK26 fan helps distribute heated air from within the firebox out into the room. The fan is controlled by a snapstat that turns power on and off as the firebox temperature rises above and falls below a preset temperature. -
Page 25: Limited Lifetime Warranty
PRODUCT COVERED BY THIS WARRANTY All Vermont Castings gas stoves, gas inserts, and gas fireplaces, and all Majestic or Northern Flame brand gas fireplaces equipped with an Insta-Flame Ceramic Burner, or standard steel tube burner. BASIC WARRANTY Vermont Castings , Majestic Products (hereinafter referred to collectively as the Company) warrants that your new Vermont Castings or Majestic Gas Fireplace/Stove is free from manufacturing and material defects for a period of one year from the date of purchase, subject to the... - Page 26 Vermont Castings, Majestic Products 410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 • 905-670-7777 www.majesticproducts.com • www.vermontcastings.com...
Need help?
Do you have a question about the Radiance RUVSOD 3370 and is the answer not in the manual?
Questions and answers