Install Optional Fk20 Fan Kit - Vermont Castings Intrepid INDVRCB Homeowner's Installation And Operating Manual

Unpack the Stove
The stove is shipped fully assembled on its back. Un-
pack the stove and carefully set it upright.
CAUTION
Porcelain enamelled surfaces are fragile. Handle
porcelain enamelled castings tenderly. Familiarize
yourself with the assembly steps before you begin
and proceed with deliberation and care. If possible,
have assistance available.
Place enamelled castings on a soft, cushioned sur-
face until you are ready to assemble.
Avoid contact between the castings and other hard
surfaces or objects.
NOTE: Verify the two relief doors (located on top of
the firebox) are properly seated on the gasket. The
doors sit flush on the gasket, and should lift easily
from the seal around the opening.
If you are installing the fan, install it before com-
pleting the stove venting.
If you are not installing a fan, proceed to the ap-
propriate vent assembly section.
Install Optional Fan Kit FK20
Fan Kit Contents:
•
#10 x 1/2" phillips screws, 2
•
Control Knob
•
Retaining Nut
•
Snapstat Bracket
•
Blower Assembly w/ Rheostat Control & Snapstat
1. Remove the rear fan cover by removing the four
(4) screws holding the cover in place on the rear
shroud. (Fig. 13) Retain the screws for future use.
2. Attach the Snapstat to the bracket using two (2) #10
x 1/2" Phillips screws. (Fig. 14)
3. Locate and remove the 1/4-20 x 3/8" hex head bolt
installed in the hole in the right rear ledge of the fire-
box. (A, Fig. 14) Use that bolt to secure the snapstat
bracket to the firebox. The mounting hole is slotted to
allow you to adjust the bracket so the snapstat head
makes contact with the firebox surface. (Fig. 14)
4. Attach the fan to the firebox by reusing the two (2)
pan head 1/4-20 screws on the top edge and the two
(2) #10 x 1/2" sheet metal screws on the side edges.
(Fig. 15)
20012761
Installation
•
Wire Tie
•
Snapstat
Intrepid® Direct Vent - Rear Vent Gas Heater
Remove Four
(4) Screws
(Retain for
future use)
Fig. 13 Remove four (4) screws holding rear fan cover in
place. Retain for future use.
1/4-20 x 3/8'
Phillips Screw
1/2" Sheet
Metal
Screw
Snapstat
Fig. 14 Attach snapstat.
Upper
Flange
#10 x 1/2"
Sheet Metal
Screw
1/4-20 x 3/8"
Screws (2)
#10 x 1/2" Sheet
Metal Screw
Fig. 15 Use screws removed earlier to attach fan kit to
firebox.
5. The rheostat control switch attaches to the control
panel plate provided on the front of the stove.
•
Insert the switch box shaft through the hole in the
back of the left side of the panel, aligning the loca-
tor pin with the smaller hole in the panel. (Fig. 17)
•
Attach the retaining nut to the switch control shaft
to secure it to the plate.
KT899
KT899
FK30 remove cover
A
6/07
Snapstat Bracket
KT900
To Control
Valve
KT901
13