Download Print this page

Kenwood K-531 Instruction Manual page 45

Compact hi-fi component system
Hide thumbs


No sound can be heard when
USB flash memory or a USB
audio player is connected.
The iPod/iPhone does not
play, or the iPod/iPhone
cannot be recognized.
Unable to record to the USB
The remote control does not
Microcomputer malfunction.
Manufactured under license from Real Sound Lab, SIA.
CONEQ is a trademark of Real Sound Lab, SIA.
"Made for iPod" and "Made for iPhone" mean that an electronic accessory has been designed to connect
specifically to iPod, or iPhone, respectively, and has been certified by the developer to meet Apple
performance standards. Apple is not responsible for the operation of this device or its compliance with
safety and regulatory standards. Please note that the use of this accessory with iPod, or iPhone may
affect wireless performance.
iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of Apple Inc., registered in the U.S.
and other countries.
Windows Media is a trademark of Microsoft Corporation registered in the U.S. and other countries.
The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by
JVC KENWOOD Corporation is under license.
Plug in the USB flash memory correctly. (P.30)
Connect the USB cable correctly. (P.30)
Check to make sure the USB audio player is turned on.
Format the USB flash memory with the FAT32 format on a PC. (Be
aware that the all recorded data on the USB flash memory is deleted if
Use other USB flash memory.
The iPod/iPhone is connected to the
of the System does not support the iPod/iPhone connection.
Make sure the USB device is not full.
Make sure the USB device is not copy-protected.
Make sure the connected USB device is compatible with this System.
The number of files/folders on the USB device reaches the limit for the
number that the System can recognize. Erase unwanted files/folders.
Load new batteries. (P.13)
Use the remote control within its effective range. (P.13)
Malfunctions may occur due to an external cause or because a
connection cord was unplugged while the System was turned on.
Follow the procedure below to reset the microcomputer.
~ Unplug the power cord from the AC wall outlet.
Ÿ Plug the power cord back in while holding down [ B ] on the main
unit. Press and hold the button until the display below is shown.
Resetting of the microcomputer starts.
! When resetting is complete, the main unit returns to Standby Mode.
Bear in mind that resetting will erase any stored information and
will restore the System's default settings.
terminal. The



  Related Manuals for Kenwood K-531