Kenwood K-531 Instruction Manual page 44

Troubleshooting
Symptoms
A radio broadcast cannot be
received.
A radio broadcast has
interference from noise.
Automatic presetting does
not work.
Pairing cannot be done.
Connection failed.
The sound skips or
fluctuates, or the connection
is lost.
The iPod/iPhone cannot be
attached firmly.
No sound can be heard from
the iPod/iPhone.
The iPod/iPhone cannot be
charged.
The iPod/iPhone does not
play, or the iPod/iPhone
cannot be recognized.
44 44 44
K-531 K-531 K-531
Connect the antennas. (P.8)
Connect the black and white cords of the AM loop antenna correctly.
(P.8)
Select the broadcast band (AM or FM). (P.22)
Tune the radio to the frequency of the desired station. (P.22)
Install an outdoor antenna away from roads.
Turn off any electrical appliances that may be causing interference.
Move the System away from the TV.
Perform automatic presetting again. (P.23)
Manually preset stations with frequencies that you can receive. (P.23)
Reduce the distance between the System and the BLUETOOTH device.
Pairing may not be possible if there are other BLUETOOTH devices
around the System. In this case, turn off the other BLUETOOTH devices.
Check whether the connected audio player supports A2DP (Advanced
Audio Distribution Profile) or AVRCP (Audio/Video Remote Control
Profile). (P.14)
Disconnect and connect again. (P.25)
Delete the registered information and pair the device again. (P.25, 27)
Reduce the distance between the System and the BLUETOOTH device.
Make sure there is no obstacle between the System and the
BLUETOOTH device.
Turn down the volume of the connected BLUETOOTH device.
Check to see whether the correct dock adapter is used. Then check to
see whether the connector between the iPod/iPhone and the System
is not damaged, and reconnect them. (P.28)
The iPod/iPhone is not properly connected. Remove the iPod/iPhone
from the System, and then connect it again. (P.28)
The iPod/iPhone is not properly connected. Disconnect the iPod/
iPhone from the System, and then connect it again. (P.28)
Reset the iPod/iPhone while disconnected from the System, then
unplug and plug the power cord. (For reset of iPod/iPhone, refer to the
Apple web site.)
The iPod/iPhone is connected to the
of the System does not support the iPod/iPhone connection.
Solution
terminal. The terminal