Page 1
**Refer to page 2 if you want to know system configuration. * Refer to parts list on page 27. KENWOOD-Corp. certifies this equipment conforms to DHHS In compliance with Federal Regulations, following are repro- Regulations No.21 CFR 1040. 10, Chapter 1, subchapter J.
SPECIFICATIONS ........Back cover ADJUSTMENT ............12 Attention Please contact our KENWOOD Service Department in your side if you want the service information; Circuit Description. Full Described Parts list and so. Information is available to you by internet from us. Accessories FM Antenna(1)
RXD-355 EXTERNAL VIEW Cabinet(TOP) (A02-3014-08) ANTENNA FM Antenna (E70-0145-08) AC power cord bushing (J42-0338-08) LOOP AC power cord FM 50kHz AM 9kHz SPAN (E30-2881-08) SELECTOR FM 100kHz AM 10kHz VIDEO Pin jack /AUX 230V (E63-1219-08) 240V Lock terminal board (E70-0151-08)
RXD-355 DISASSEMBLY FOR REPAIR Caution on Disassembly Follow the below-mentioned notes when disassembling (A1)x2 Top Cabinet the unit and reassembling it, to keep it safe and ensure ø3x12mm excellent performance: 1. Take cassette tape and compact disc out of the unit.
Page 5
RXD-355 DISASSEMBLY FOR REPAIR (L2) x1 CLAMP LEVER Turntable CAM GEAR RIB Disc Tray (L1) x2 Figure 8-1 CD Player Unit Figure 8-4 (E2)x2 (E3)x1 (M1) x3 (E4)x1 Main PWB (M1) x3 Figure 8-5 Figure 8-2 (H2)x1 (N1)x1 CD Player...
Page 6
RXD-355 DISASSEMBLY FOR REPAIR (P2) x3 Mechanism Loading Motor (P1) x1 (P1) x1 TAPE2 Record/Playback Head (Q1) x5 Erase Head Figure 9-1 (A1)x2 Ø2x9mm Figure 10-1 REMOVING AND REINSTALLING TAPE1 THE MAIN PARTS Playback Head TAPE MECHANISM SECTION Perform steps 1 to 7 and 9 of the disassembly method to remove the tape mechanism.
Page 7
RXD-355 DISASSEMBLY FOR REPAIR How to remove the belt (TAPE 2) (See Fig. 10-4) 1. Remove the main belt (E1) x 1 pc., from the motor side. 2. Remove the FF/REW belt (E2) x 1 pc. Motor How to remove the motor (See Fig. 10-5) 1.
RXD-355 CIRCUIT DESCRIPTION 1. Test Mode 1-1 How to Set up the Test Mode During POWER OFF mode, push below each 2 keys and [POWER] key. Then go to each TEST MODE. KEYS TEST MODE [ POWER ] [ SOUND ] + [ CD ]...
Page 10
RXD-355 CIRCUIT DESCRIPTION 1-3-2 Software Reset Function: Software RESET. All the function condition will be initialize. It will jump to A operation in case of power ON. After display "CLEAR ALL", power will off. Forwarding condition set for CD changer.
Page 11
RXD-355 CIRCUIT DESCRIPTION 1-3-4 CD Changer Aging Test Mode START " " KEY TRAY OPEN IF THE ERROR OCCURS, GO TO ERROR MODE DISC SKIP DISC SKIP DISC SKIP TRAY CLOSE DISC X PLAY DISC SKIP DISC Y PLAY DISC SKIP DISC Z PLAY 2.
RXD-355 ADJUSTMENT TUNER SECTION fL : Low-range frequency fH : High-range frequency • AM IF/RF Signal generator : 400HZ, 30%, AM modulated Test Stage Frequency Frequency Display Setting/Adjusting Parts Instrument Connection AM IF 450kHz 1620kHz T351 ✽ AM Band Coverage 522kHz (fL) : T306 1.1±0.1V...
Page 15
The DC voltage is an actual reading measured with a high impedance type voltmeter with a cassette loaded at playback mode. The measurement value may vary depending on the measuring instruments used or on the CD SECTION product. Bias circuit DC voltage is measured while in the record mode. 5.0V 3.2V DOLBY and the double-D symbol are trademarks of Dolby Laboratories...
Page 19
RXD-355 EXPLODED VIEW (CD MECHANISM) AL SCREW : N09-5335-08 AM ø3x8 : N09-5332-08 AN ø2.6x6 : N32-2606-46 AQ ø2x3 : N30-2003-46 AR WASHER : N19-1435-05 AS ø2x5 : N86-2005-46 PWB-F PWB-B PWB-C Parts with exploded numbers larger than 700 are not supplied.
Page 21
Ref. No Description Parts No. Parts No. Description Ref. No Parts nation marks ress ress Parts nation marks H10-7771-08 POLY FOAM FIXTU SPAKA0307AWZZ RXD-355 H10-7772-08 P-ADD(TOP) SPAKA0107AWZZ H10-7773-08 P-ADD(BTM) SPAKA0108AWZZ A02-3014-08 CABINET(TOP) GCAB-1195AWSA H25-1706-08 BAG(UNIT) SSAKH0061AWZZ A02-3015-08 CABINET(R) GITAS0092AWSA H25-1707-08...
Page 22
✽ New Parts ✽ New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Teile ohne Parts No.
Page 23
✽ New Parts ✽ New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Teile ohne Parts No.
Page 24
✽ New Parts ✽ New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Teile ohne Parts No.
✽ New Parts ✽ New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Teile ohne Parts No.
Page 26
✽ New Parts ✽ New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Teile ohne Parts No.
RXD-355 PARTS LIST HOW TO READ THE PARTS LIST ABBREVIATION OF MODEL AND MASS PRODUCTION'S DESTINATIONS Australia Canada China England Europe Germany Korea Malaysia MODEL ABB. RXD-355 RXD-355-H RXD-355E RXD-355E-H RXD-355M RXD-355M-H Mexico PX/AAFES Russia Scandinavia Shanghai Other area ABB.