Networks; Table 7: Networks Definitions - Grandstream Networks GXW410x User Manual

Syslog Level
Security
Download Configure

NETWORKS

Basic Settings
IP Address
DHCP hostname
DHCP domain
DHCP vendor class ID
PPPoE account ID
PPPoE password
PPPoE Service Name
Preferred DNS server
Time Zone
Allow DHCP Option 2 to
override Time Zone
Settings
Advanced Settings
Layer 3 QoS
Grandstream Networks, Inc.
Firmware Version 1.4.1.5
Select the GXW to report the log level. Default is NONE. The level is one of DEBUG,
INFO, WARNING or ERROR. Syslog messages are sent based on the following
events:
1. product model/version on boot up (INFO level)
2. NAT related info (INFO level)
3. sent or received SIP message (DEBUG level)
4. SIP message summary (INFO level)
5. inbound and outbound calls (INFO level)
6. registration status change (INFO level)
7. negotiated codec (INFO level)
8. Ethernet link up (INFO level)
9. SLIC chip exception (WARNING and ERROR levels)
10. memory exception (ERROR level)
The Syslog uses USER facility. In addition to standard Syslog payload, it contains the
following components: GS_LOG: [device MAC address][error code] error message
Example: May 19 02:40:38 192.168.1.14 GS_LOG: [00:0b:82:00:a1:be][000] Ethernet
link is up
Downloads the current configuration of the GXW410X

TABLE 7: NETWORKS DEFINITIONS

There are two modes to operate the GXW410x:
DHCP mode: all the field values for the Static IP mode are not used (even though
they are still saved in the Flash memory.) The GXW410x acquires its IP address from
the first DHCP server it discovers from the LAN it is connected.
Using the PPPoE feature: set the PPPoE account settings. The GXW410x will
establish a PPPoE session if any of the PPPoE fields is set.
Static IP mode: configure the IP address, Subnet Mask, Default Router IP address,
DNS Server 1 (primary), DNS Server 2 (secondary) fields.
This option specifies the name of the client. This field is optional but may be required
by some Internet Service Providers. Default is blank.
This option specifies the domain name that client should use when resolving
hostnames via the Domain Name System. Default is blank.
Used by clients and servers to exchange vendor-specific information. Default is
Grandstream GXW410x.
PPPoE username. Necessary if ISP requires you to use a PPPoE (Point to Point
Protocol over Ethernet) connection.
PPPoE account password.
This field is optional. If your ISP uses a service name for the PPPoE connection,
enter the service name here. Default is blank.
This field will let the user enter a preferred DNS server to be used instead of the one
acquired by the service provider.
Controls how the date/time is displayed according to the specified time zone.
Default is No. If set to Yes, time zone settings will originate from the DHCP server.
This field defines the layer 3 QoS parameter which can be the value used for IP
Precedence or Diff-Serv or MPLS.
Default value is 48. Its range lies from 0 to 63.
GXW410x User Manual Page 15 of 32
Last Updated: 5/2014