Maintenance; Table 6: Maintenance Definitions - Grandstream Networks GXW410x User Manual

MAINTENANCE

Web/Telnet access
Web Access
Web Port
End-User Password
Admin Password
Upgrade/Provisioning
Firmware Upgrade
Provisioning
Via TFTP Server
Via HTTP Server
Firmware Server Path
Config Server Path
Firmware File Prefix
Firmware File Postfix
Config File Prefix
Config File Postfix
Allow DHCP Option 66 to
override server
Automatic Upgrade
Syslog Setup
Syslog Server
Grandstream Networks, Inc.
Firmware Version 1.4.1.5

TABLE 6: MAINTENANCE DEFINITIONS

Select HTTP or secure HTTPS protocol for Web Access
This option defines Web Port desired to use. This field is optional. Default is 80 for
HTTP and 443 for HTTPS.
This contains the password to access the End-user Web Configuration Menu (Status
and Basic Settings). This field is case sensitive with a maximum length of 25
characters.
Contains the password to access administrative settings other than Basic Settings and
Status Page.
&
This radio button will enable GXW410x to download firmware or configuration file
through either TFTP or HTTP.
If selected, the GXW410x will attempt to retrieve new configuration file or new code
image from the specified TFTP server at boot time. It will make up to 5 attempts before
timeout and then it will start the boot process using the existing code image in the
Flash memory. If a TFTP server is configured and a new code image is retrieved, the
new downloaded image will be verified and then saved into the Flash memory.
Note: Please do NOT interrupt the TFTP upgrade process (especially the power
supply) as this will damage the device. Depending on the network environment this
process can take up to 25 or 30 minutes.
The URL for the HTTP server used for firmware upgrade and configuration via HTTP.
For example, ttp://provisioning.mycompany.com:6688/Grandstream/1.0.0.54
Here ":6688" is the specific TCP port that the HTTP server is listening at, it can be
omitted if using default port 80.
Note: If Auto Upgrade is set to No, GXW410x will only do HTTP download once at boot
up.
IP address or domain name of firmware server.
IP address or domain name of configuration server.
Default is blank. If configured, GXW410x will request firmware file with the prefix. This
setting is useful for ITSPs. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Default value is No. If set to Yes, configuration file will originate from the DHCP server.
Choose Yes to enable automatic upgrade and provisioning.
firmware every" field, enter the number of minutes to enable GXW410x to check the
server for firmware upgrade or configuration. When set to No, GXW410x will only do
upgrade once at boot up. Other options are:
" Always check for New Firmware."
" Check New Firmware only when F/W pre/suffix changes"
" Always skip the Firmware check"
The IP address or URL of System log server. This feature is especially useful for ITSP
(Internet Telephone Service Provider)
GXW410x User Manual
In "Check for new
Page 14 of 32
Last Updated: 5/2014