Installation; Unpack Appliance; Remove Window; Convert From Rear Outlet To Top Outlet - Valor Portrait 530ILN/ILP Installation & Owner's Manual

Unpack Appliance

Beware of sharp edges! Wear gloves!
1. Remove the cardboard wrapping and the wood
pallet from the appliance and discard.
2. Unpack any loose items from around the appliance.
3. Remove the window and set aside in a safe place to
avoid damage—see next page.
4. Verify that you have all the components required
for the installation, including:
•
liners and fuel bed (in separate cartons);
•
front / stove casing with barrier screen;
•
venting components and accessories;
•
electrical components if installing optional
blower.

Remove Window

1. Release the top of the window by pulling forward
and rotating outwards the two bars at the top
corners.
2. Unscrew the two
spring-loaded
bolts securing
the bottom of the
window.
3. Carefully lift the
window. Keep the
window and bolts
in a safe place.
4. Remove the
packaged ceramic
(Bricks/Logs/
Coals/Rocks)
from fi rebox.
Remove Burner Module
It may be desirable to remove the burner module to
gain access for gas fi tting, to install a fan kit, or to
fasten the unit to the fl oor or plinth supplied with the
zero clearance fronts.
Gas line access at
rear left corner

Installation

Remove 11 screws to
remove burner module

Convert from Rear Outlet to Top Outlet

(co-axial venting)

If installing with rear vent outlet, go to next step.
1. Remove the top plate and seal by unscrewing
12 screws. Keep the seal, plate and screws for
fi tting to the back.
2. Remove the rear outer vent collar and seal by
unscrewing 12 screws.
3. Remove the rear inner vent collar and seal by
unscrewing 8 screws.
4. To make sure that the collars are axially aligned,
fi t the adapter 817VAK over the outer vent collar.
5. Position the inner collar and seal vertically inside
the top of the appliance. Drop the outer collar with
adapter over the inner collar to ensure alignment.
Secure the inner collar with 8 screws and the outer
collar with 12 screws.
6. Fit the plate and seal (which was previously
removed from the top) to the back of the appliance
with 12 screws.
QUALIFIED
INSTALLER
29