Dalsa Spyder3 User Manual page 73

Spyder3 Color Manual
In the case of a slow transition (that is, when the EXSYNC line rate increases by less
than 10% of the previous line rate) a line readout will not become corrupt.
There are also limitations on the exposure time when operating in auto mode: If the
line rate exceeds half the maximum line rate, then the exposure time cannot exceed
the time stated in
Note: DALSA recommends Auto mode for most users.
For information on artifacts that may be experienced while using this mode, see the
Artifacts section below.
Please note: The graphic below explains the relationship between the following
tables and the preceding figure, Gate Dark Current Clear.
Dark Current Dump to Immediate Readout: Multi-Line Artifacts.
SRM 0, Auto Mode.
Time Period
T
0
T
1
SRM 0, Auto Mode.
Time Period
T
0
T
1
DALSA
.
Table 18
Operating Region
Operating Region
Operating Mode
Dark Current Dump state
Immediate Readout state
Operating Mode
Immediate Readout state
Dark Current Dump state
03-032-20059-01
73