Timer Recording - Loewe TV set Operating Instructions Manual

Connecting other equipment – Timer recording
Calling the program preview:
Page forwards
Select recording time
Transfer recording data to the VCR
programming:
MEN
VCR programming
Program Start Stop
1 ARD 2O:15 21:45 28.O8 on 1
--- --:-- --:-- --.--
--- --:-- --:-- --.--
Select EURO-AV socket AV 1 or
–
AV 2
94
VCR programming
From the program preview pages, you can select the data: program, date, start time and
stop time for a certain broadcast and transfer these data into a „VCR programming" table.
Three VCR programming tables are available. A Loewe video recorder connected to the
EURO-AV socket can then record this broadcast on timer control. In this way you can also
record satellite programs comfortably from the satellite receiver unit of the TV with your
Loewe video recorder.
Calling the preview page
Press the TV guide button
The current program preview appears on
pressing the green button
Press the green button
the next preview page. Turn back with the
backwards
red button
Transferring recording data:
1. Select the start time of the broadcast
with the blue buttons
<record: M>
appears at the bottom of the picture.
2. As long as this display is visible, you can
transfer the data to the VCR
programming by pressing the
button. Note: If you have chosen a
station without TOP teletext
transmission, it may not be possible to
read the time or date or both. If you try
to transfer timer data in this case,
„Timing functions - date or time"
appears. Enter the missing data
otherwise no accurate timer recording is
possible! Take any time differences into
account for foreign stations and correct
the start time, e.g. in the recording
timer.
Date VPS AV
3. Depending on which EURO-AV socket the
video recorder is connected to, set 1 or
--- -
--- -
2 for <AV> with the
.
.
again to turn to
.
.
MEN
button.
–
Preparing the video recorder for
recording
Check that the video recorder is connected
to the TV set with an AV cable.
1. Insert a blank tape.
2. Set the video recorder to AV mode
(AUX).
3. Set the „Remote" switch on the video
recorder to TV so that the recorder can
be operated with the TV remote control.
4. Switch the recorder to standby.
Notes:
1. This can only be controlled in a Loewe
video recorder which has a „Remote
VTR-TV" circuit.
2. Make sure the timer times do not
overlap. You can only make one timer
recording at a time, never several
simultaneously.