Timer Recording - Loewe CT1163 Operating Instructions Manual

Connecting other equipment – Timer recording
Calling the program preview:
Page forwards backwards
Select recording time
Transfer recording data to the VCR
programming:
MEN
VCR programming
Program Start Stop
O1: ARD 2O:15 21:45 28.O8
-- --:--
-- --:--
42
VCR programming
From the program preview pages, you can select the data: program, date, start time and
stop time for a certain broadcast and transfer these data into a „VCR programming" table.
Three VCR programming tables are available. A Loewe video recorder connected to the
EURO-AV socket can then record this broadcast on timer control. In this way you can also
record satellite programs comfortably from the satellite receiver unit of the TV with your
Loewe video recorder.
Calling the preview page
Press the TV guide button
The current program preview appears on
pressing the green button
Press the green button
the next preview page. Turn back with the
red button
Transferring recording data:
1. Select the start time of the broadcast
with the blue buttons
<record: M>(=MEN)
appears at the bottom of the picture.
2. As long as this display is visible, you can
transfer the data to the VCR
programming by pressing the
button.
„VPS On" or „VPS Off" flashes.
3. With the
want to record with or without VPS.
Note: If you have chosen a station
without TOP teletext transmission, it may
not be possible to read the time or date
or both. If you try to transfer timer data
in this case, „Timing functions - date or
time" appears. Enter the missing data
otherwise no accurate timer recording is
possible! Please take into account any
time differences for foreign stations and
Date VPS
correct the start time in the recording
on 1
timer, for example, if no VPS is
--:-- --.--
--:-- --.--
broadcast.
.
.
again to turn to
.
.
MEN
button, select whether you
–
Preparing the video recorder for
recording
Check that the video recorder is connected
to the TV set with an AV cable.
1. Insert a blank tape.
2. Set the video recorder to AV mode
(AUX).
3. Set the „Remote" switch on the video
recorder to TV so that the recorder can
be operated with the TV remote control.
4. Switch the recorder to standby.
Note:
This can only be controlled in a Loewe
video recorder which has a „Remote VTR-
TV" circuit.
Make sure the timer times do not
overlap. You can only make one timer
recording at a time, never several
simultaneously.