DFI G5M300-P User Manual page 79

IDE Primary Master/Slave UDMA and IDE Secondary Master
UDMA
These fields allow you to set the Ultra DMA in use. When Auto is
selected, the BIOS will select the best available option after checking
your hard drive or CD-ROM.
Auto The BIOS will automatically detect the settings for
you.
Disabled The BIOS will not detect these categories.
On-Chip Serial ATA Setting
This section is used to configure the serial ATA drives.
SATA Mode
IDE This option configures the Serial ATA drives in IDE mode.
RAID This option enables the RAID function for Serial ATA
drives.
On-Chip Serial ATA
Disabled
Auto
Combined Mode This option allows you to use both IDE and
Enhanced Mode This option allows you to use both IDE and
SATA Only
Disables the onboard SATA.
The system will detect the existing SATA and
IDE drives then automatically set them to the
available master/slave mode.
SATA drives; allowing a maximum of 4 drives.
You must manually set the SATA drives' mas-
ter/slave mode in the "Serial ATA Port0 Mode"
and "Serial ATA Port1 Mode" fields.
SATA drives; allowing a maximum of 6 drives.
This option automatically sets the SATA drives
to Primar y Master and Secondar y Master
modes. Since both drives are in master mode,
you cannot set the IDE drives to Master mode.
The "Serial ATA Port0 Mode" and "Serial ATA
Port1 Mode" fields will not be configurable.
3
BIOS Setup
7 9