Jumper Setting For Devices On Board; 2-5.1 Jbat1 For Clear Cmos Data - SOLTEK SL-75LIV User Manual

75LIV

2-5 JUMPER SETTING FOR DEVICES ON BOARD

• The following diagrams show the locations of jumper blocks on the
mainboard.
CAUTION
• Do not remove the jumper when power is on. Always make sure the power
is off before changing any jumpers. Otherwise, mainboard could be
damaged..
• All jumper pins covered with black marks are closed pins.

2-5.1 JBAT1 For Clear CMOS Data

A battery should be used to supply the power for the CMOS RAM to retain
the mainboard configuration.
SOCKET 462
FAN2
AC'97
Codec
1 3
WOL1
1
USB2
NOTE:
You can clear CMOS by 2-3 pin closed when the system is POWER
OFF. Then, return to 1-2 pin closed position (default). You may damage
the mainboard if clearing the CMOS with POWER ON. Unplugging the
power cord from power supply before clearing CMOS will be a safest bet
for user.
1 3 FAN1
SW1
Clock
Generator
VIA
VT8361
Li
PCI 1
Battery
PCI 2
VIA
VT82C
PCI 3
686B
16
ISA
JBAT1 For Clear CMOS Data:
Clear CMOS Data
Retain Data
(default)
24
3
JBAT1
1
3
JBAT1
1